Aquila ATO1, Maintenance Manual

Page: 30 / 198

MAINTENANCE MANUAL
AQUILA AT01
Aviation by Excellence AG
Page 08
05-20-00
Maintenance Checks
1. Fuselage Shell - Visual Inspection for paint coat damages, X
dents, cracks, holes, distortion and other evidence of failure.
All unpainted parts for delaminations (white spots).
2. Lower Fin - Inspect fin and lower rudder for signs of X
breakage. Check skid plate for wear.
3. Canopy - Examine the acrylic glass for cracking, crazing X
and general condition. Check the canopy locking
mechanism operates correctly. Check wear of parts.
Inspect tubular canopy hinge frame and brackets for cracks,
distortion, corrosion, wear, and security of attachment.
Check the gas spring strut for sufficiently power and
evidence of leakage.
4. Baggage Door - Check door seal, door latching mechanism, X
and door hinge for defects and condition. Inspect door
structure for cracks or other damage.
5. Restraint Assy Pilot / Co-Pilot - Check for proper operation, X
condition, and security of attachment.
6. Seats - Verify security of attachment of the seat assy to X
aircraft structure. Check operation of seat adjustment
mechanism and seat stops. Inspect gas spring struts for oil
leakage or other damage.
7. Seats - Remove seats. Clean and lubricate seat rails as 25-10-00 Ann.
required. Visually examine that portion of the engine
controls, lines, and cables, located in the center console.
8. Main Landing Gear - Inspect fuselage structure at such X
points and areas where the main landing gear is attached.
No. Fuselage / Cabin Reference Interval Initials
100 h Add.
30.04.08
No. Propeller (Cont.) Reference Interval Initials
100 h Add.
5. Propeller Blades - Check blade angle play. (max. 2°) X
6. Hub - Inspect outside condition of the hub and parts for X
cracks, corrosion and deterioration.
7. Check Nuts for Low Pitch - Inspect for tightness and X
safety wire.
8. Propeller Assy - Check all safety means to be intact. X
9. Propeller Flange Stop Nuts - Check correct torque X
value (45 - 47 Nm).
10. Propeller Blades - Visual Inspection for damages and MT* E-124 X
their repair. Install Spinner as required. Para. 6.2.1
thru 6.10