51
The connectivity of the Aquatronica Touch Controller to Internet is achieved through the setting of 3 main
parameters:
•
General Settings: Setting of parameters that make the Touch Controller communicating with the router,
which acts as a bridge.
•
Email Settings: Settings for the email service configuration.
•
Remote access Settings: Settings that grant the access to the Touch Controller from the Web.
GENERAL
(LAN CABLE CONNECTION)
At first, connect the Aquatronica Touch Controller to the router through the RJ45 LAN cable (included in the package).
Once connected, enter the Touch Controller Main Menu and select the ETHERNET icon.
The Ethernet Menu opens and the submenu icons appear on the left. Now select GENERAL.
Enable the LAN interface by selecting “ON” mode on the main screen and be sure that the WLAN interface is OFF.
Once the LAN interface is enabled, it appears the button for setting the
LAN
parameters. Click SETUP.
General
Email Test
Email Settings
OK
Remote Access
Ethernet
Enable LAN Interface
Enable WLAN Interface
ON
Setup
ON
Setup
General
Email Test
Email Settings
Remote Access
Ethernet
DHCP
ON
IP Address
Subnet Mask
Gateway
MAC
DNS1
DNS2
For an automatic configuration, set the DHCP on “ON”
mode. The Touch Controller will automatically receive from
the router all the required parameters.
Expert users might decide to set the values manually by
selecting DHCP on “OFF” mode.
In this case each user must contact its own Internet
provider in order to get the correct values to input.
If the DHCP is on “ON” mode, press OK. The reloading
appears, press OK and click on the Aquatronica logo to
return back to the Home page. Wait at least 30 seconds
before performing any other operation.
After these 30 sec., enter the SETUP menu and note down
the IP code that the router has assigned to the Touch
Controller. The Touch Controller will use this IP for the
connection to the LAN net.
OK
