ACT 2009
- 7 -
OPERATION
Once installation has been completed as described on pages 4 and 5, open water
supply valve to sensor unit. If the water is not up to normal operating level in the pool,
manually adjust the water level to that point.
After level is set and water is at normal operating level, it is time to power the
control unit. Plug the unit into the 120 VAC, 60 Hz electrical outlet; turn the on/off
toggle switch on the side of the controller to the ON position. The unit will go through a
self-test and beep to let you know it is on.
Once power is applied to the controller there are settings in the menu that can be
changed. You can scroll through the menu by pressing the up and down arrows. The enter
button will bring you back to the startup screen. Options can be changed by following the
directions below.
The first six screens as you scroll down through the menu are for informational
purposes. The screens give you the following information.
S
TARTUP
S
CREEN
This screen will tell you the version of code that your controller is running.
S
CREEN
1
This screen will tell you what your controller settings are for Delay Time To
Shutoff and Maximum Fill Time.
S
CREEN
2
This screen will tell you what your controller settings are for Manual Override
and Delay To Normal.
S
CREEN
3
This screen will tell you what your controller settings are for Level Sensor Type
and Alternate Sensor Option.
S
CREEN
4
This screen will tell you what the Last Fill Time was.
S
CREEN
5
This screen will tell you what the Last Drain Time was.
S
CREEN
6
This screen will tell you when the Last Alarm was.
Summary of Contents for ELC-810 Series
Page 6: ...ACT 2009 6...
