4
• Follow these instructions to properly use the pump, its accessories, connectors, etc. The pump must
be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be
considered a case of misuse.
• This Pump is not intended for use by persons (including children) with reduced physical, sensory
or reduced mental capabilities, or lack of experience and knowledge, unless they have been given
supervision, instructions & training concerning use of the Pump by a person responsible for their
safety.
• It is necessary to keep children under surveillance, and to make sure that they are not playing with
the Pump, or its power cord.
•
Keep children away from the Pump when operating.
SYMBOLS
The Pump must not be disposed of with normal household waste but must be disposed of in
accordance with local environmental regulations.
Conformity with safety rules applicable in the EU market.
PLEASE Read the instructions before plugging in the Pump and using
To be checked before you Start
• These Pumps have been designed to suck
CLEAN WATER ONLY.
• They are NOT designed to suck DIRTY WATER
or suspended soft solids, sand, silt, slurry etc.
•
The Pump must be installed on a flat and solid surface.
•
It is BEST PRACTICE to place several pavers on the floor of your Tank to sit the Pump upon so as
any sediment is not easily picked up off the floor of your Tank. Any sediment picked up could harm
the pump and will certainly send dirty water up the line (and affect activities such as clothes washing,
etc). If Drinking – be sure to have a UV Water Filtration on the Delivery side of the System.
The Pump is not suitable for commercial or professional use (including continuous operation) where the
Pump may run 24-7-365. This Pump is for general household, garden use, and pool-top up ONLY. If the
Pump is used for anything other than per the instructions in this Manual, your Warranty may be voided.
2. Getting Started
1. Connect a discharge pipe with a diameter at least equal to the diameter of the pump outlet (40mm)
2. Remove Plug & FILL the Pump with WATER to be sucked, by making an angle of 45 degrees ( to
reduce the amount of air trapped in the pump body )
3. If the Pump rests on the bottom of your Tank (i.e. it is not suspended by Stainless Steel tether
cable or nylon rope etc ) , make sure it is on a flat and stable elevated surface ( upon 1 or 2 pavers )
4. Make sure that no one is present in the Tank or Vessel holding your water
5. Plug the Pump into the 240 Volt Mains Power Outlet and Switch ON
