Changing parameters:
The Control Unit uses several software parameters to control the counting. Depending on your
specific installation an operation of the system, some of these parameters may need to be adjusted by
the operator.
When the Control Unit asks for Weight for the first connected Registration Unit, it will accept special
commands. All commands are initiated with
Delete
key
.
Whenever
Delete
is pressed as the first
command a
?
is shown. The next character will overwrite the
?
. If
Delete
is pressed again the
?
will
disappear.
To change parameters in setting #1, use the following code:
Delete < > 3 Enter
This code contains parameters which will set up how the Control Unit responds to other equipment.
To change parameters in setting #2, use the following code:
Delete < > 4 Enter
This code contains no parameters which will set up how the Control Unit responds to other
equipment.
The arrow buttons may be used to navigate between parameters in each code set.
To move to the next parameter in a code set, press
>
(6/> key) or
N
.
To move to the previous parameter in a code set, press
<
(5/< key
)
.
To move to the first parameter in a code set, press
^
(7/^ key
)
.
To move to the last parameter in a code set, press v
(8/v key
)
.
To leave a code set, press
Stop,
or at the last parameter in a set press
N
or edit it.
To edit a parameter, press
Y
, and then give the new value, followed by
Enter
. If
Enter
is pressed
without any value, the original value is kept.
Changing language:
In order to change language (English or Norwegian), or to look at program
versions and serial number, use this code:
Delete < > 0 Enter
If the language is set to Norwegian the display will show:
Answer
Y
, and set LNG=
1
. Press
Enter
. The program versions are now
displayed, and another press at
Enter
will show the serial number for the Control
Unit. Press
Enter
once more
in order to proceed to WEIGHT.
WEIGHT(g) C
x
:
LNG=0 Ny?
Page 17 of 20
Summary of Contents for CSE Series
Page 19: ...Page 19 of 20...
Page 20: ...Page 20 of 20...
