AQ1B Compact Underwater Metal Detector
User Manual
8.
The image below shows the upper and lower stems attached to the 38cm loop &
fitted the AQ1B control module.
9.
With all the AQ1B configurations the control unit can optionally be used with a
waist belt as shown below, the belt is fitted with a quick release cam buckle for
securing the belt in place. The method of assembly is similar to section 6 above.
First the module Velcro is engaged with the Velcro on the inside of the belt; then
the inner straps are closed to secure the module to the belt.
Care and Maintenance
Proper care of your
Aquapulse
will be repaid by a long and trouble free life and
attention should be given to the following points: -
1.
After use, and before removing plugs, make sure that the unit is switched off,
wash down with clean fresh water.
NEVER use chemicals to clean your
detector as these will damage o-rings and seals, which can cause them to fail
and allow the incursion of water into the control unit.
2.
Dry the detector paying particular attention to the area around the plugs.
Clear any excess water by blowing. It is very important to keep the Ikelite
connector sockets and pins clean and dry when not in use. Dirty or corroded pins
and/or sockets will seriously degrade the performance of your detector. After
11
