AquaPur AFR 3 B1, Operating Instructions Manual

Page: 9 / 76

- 6 -
GB
Usage
NOTE
► This lint remover can damage structured fabrics
or very soft materials such as angora. Therefore,
always test the lint remover on an inconspicuous
part of the garment and turn the transparent part
of the spacer
1
first to the level “Thick” and then
press the On/Off switch/Speed switch
5
twice.
The appliance now runs at speed level I. In this
way you can gently test whether the setting is
sufficient for the garment without damaging it.
► This appliance should not be brought into con-
tact with moisture. Therefore, do not use the lint
remover on moist fabrics.
1) Lay the garment on a flat surface, such as an
ironing board. Ensure that the surface to be pro-
cessed has no wrinkles. Otherwise, the garment
could be damaged.
2) Turn the spacer
1
to the desired position or
remove it completely (see Chapter “Removing/
replacing the spacer”):
–
“Thick” for large bobbles and coarse textiles
(large distance to the cutter knives)
–
“Thin” for small lint/bobbles and fine textiles
(small distance to the cutter knives)
–
Remove the spacer, only for very fine lint (virtual-
ly no spacing to the cutter knives).
IB_114180_AFR3B1_LB4.indb 6 12.05.15 14:50
80 mm x 150 mm