Quartz Digital Concealed
installation instructions
Page 15
Trim the projecting pipe to a length of 15-22mm measured from the finished
wall surface, using a rotary type cutter. If a hacksaw is used, the pipe end must
be carefully de-burred and chamfered.
8
Clean and lubricate the pipe using a suitable (silicone based) lubricant.
9
Remove the wall outlet cover plate and carefully slide the wall outlet
onto the projecting pipe. Turn to the required position and mark the
screw holes on the wall face.
10
Remove the wall outlet and drill and prepare the wall fixings.
11
Ensure the projecting pipe is clean and lubricate
again if necessary. Run a thin bead of silicone
sealant to the rear of the wall outlet. Refit the
wall outlet and secure it to the wall using the
screws provided. Refit the wall outlet cover plate.
12
