AquaKing RED LABEL 2, Manual

Page: 28 / 34

• www.aquakingredlabel.nl • info@aquaking.nl
28
Installation Drum Filter (Illustration 1)
• Remove the cover (L) from the housing (M) and check the ballast is in the lower position.
• Slide the valve on the inlet and if necessary, open the outlet to fill the filter system with
water.
• Fill the pond until maximum water level has been reached. (See illustration 4).
• Check the water level in the housing (M).
• Check all piping, hoses and connections for leakages.
• Insert the plugs of the devices into the appropriate sockets on the control box (N) (See
indications on Controller Box (N)).
• Insert the plug (O) of the Controller Box (N) into the appropriate socket and turn it on at the
switch (P).
• Hold the push button (Q) in for 10 seconds so that the motor and high pressure pump are
activated.
• After around 20-30 minutes, the rinsing cycle should be repeated automatically.
With longer intervals you can adjust the ballast height (Z).
Attention!
When adjusting the ballast (Z)/ opening the cover (L), the power supply must always be
disconnected.
EN