Aquacal SunPower SP05, Installation Manual

Page: 26 / 108

Page - 22
1
USE ARROWS TO
"EXTERNAL CONTROL"
2
ENTER TO SELECT
3
ARROWS TO MODE
4
ENTER TO EDIT
5
ARROWS TO
"SMART"
6
ENTER TO SAVE
7
USE ARROWS TO SET
LOCAL ADDRESS
8
ENTER TO SAVE
9
CONFIRM OK TO CLEAR
ANY EXISTING SETUPS
PLEASE NOTE:
This action will wipe all previous settings
in favor of the new configuration. This
includes external controller settings,
optional device settings, groups,
equipment, schedules, and site specific
settings. Additional site specific settings
may need to be put in place.
The system will restart. If successful, the
heat pump should now display "Under
Remote Control".
10. If after 45 seconds, the heat pump displays a " SMART COMM FAULT
":
A. Confirm dip switches - If external controller uses dip switches, confirm switches are in the correct
position. Otherwise, proceed to confirm wiring.
a. Deactivate power to the external controller.
b. Remove access panel on external controller.
c. Check the external controller manual for proper dip switch positioning and confirm dip switches.
d. Reinstall electrical access panel.
e. Reactivate power to the controller.
f. If the fault persists, proceed to confirm wiring.
B. Confirm wiring - Confirm wires are oriented properly on the heat pump's "Port B" of the control board.
a. Deactivate power to heat pump and external controller.
b. Remove the access panel on the heat pump.
c. Reverse wires on "Port B".
d. Reinstall electrical access panel.
7. Reactivate power to the controller.
8. Reactivate power to the heat pump.
C. If fault continues to occur, check with the manufacturer of the external controller for additional advice on
using a heat pump with the controller.
1
-
Ins
ta
ll
at
ion