Page - 40
1.6.e Connecting a Pool/Spa Switching Relay
A direct connection to an external flow relay switch has been provided on the terminal microprocessor.
A pool/spa relay switch will automatically change between the pool and spa thermostat depending on the
position of the plumbing valves.
l
When water flows to the pool, the pool thermostat will be used.
l
When water flows to the spa, the spa thermostat will be used.
DANGER
Failure to heed the following will result in injury or death.
l
Deactivate power while routing wiring to control board.
l
Follow all National Electric Codes (NEC) and/or State and Local guidelines.
WARNING
Failure to heed the following may result in injury or death.
l
This section is only for qualified installers who are familiar with the swimming pool and spa safety standards.
l
The installer must be familiar with service industry techniques.
NOTICE
Failure to heed the following may result in damage to equipment.
l
The wire size connecting the relay switch must be a minimum 22-gauge, 2-conductor, low-voltage wire.
l
Use FS2 (
dry contact)
connection on the microprocessor.
1
-
Ins
ta
ll
at
ion
Summary of Contents for GBB
