GENERAL WARNINGS
- This filter is an equipment for the treatment of drinking water made in compliance with the DM.
25/12 and DM. 174/04, the user must use it in full compliance with this manual in order to avoid
potential risks to health or safety;
- This filter is suitable for the filtration and treatment of drinking water as defined by the competent
authorities of the place of installation and, in any case, for liquids for food use, with PH close to
neutral;
- Do not use in presence of water with unknown origin or microbiologically not pure, without providing
for the use of an adequate disinfection system;
- Use the filters in compliance with the operating pressures declared by the manufacturer. With
presence of high pressures in the circuit or "water hammer", protect the device by installing a
pressure reducer upstream;
- Except for special filters, use the filters with liquids at room temperature (20-25°C), however within
the limits indicated by the manufacturer. If used upstream of a boiler, it is recommended to install a
non-return valve to prevent boiling water from entering the filter;
- Do not use the containers for the filtration of compressed air, oil or gas, even at low pressures.
- Do not use these filters in environments exposed to freezing temperatures or high temperatures.
Therefore, installation outdoors or in places exposed to bad weather or ultraviolet rays is not
recommended;
- This equipment requires regular periodic maintenance in order to ensure the maintenance of the
drinking water requirements of the treated water.
INSTALLATION
The installation of the filter must be performed by qualified personnel capable of issuing a regular
declaration of conformity.
The typical filter assembly scheme is the
one shown in the image alongside.
It is advisable to create a bypass to
ensure maintenance of the filter cartridge
without eliminating the supply of water to
the users.
During the assembly phase it is important
to respect the inlet / outlet direction (IN-
OUT) indicated on the filter head. This is necessary to
allow the cartridges to work correctly.
To install the filter on the wall, use the appropriate wall
bracket (optional), which
allows for correct fixing
and proper spacing from
the wall, necessary to
ensure the opening of the
filter with the use of the
appropriate key.
Summary of Contents for FP2
Page 2: ......
