21
AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO, TEMECULA, CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
Quartz Sleeve
Lamp
Clip Connector
Clip Connector
NOTE:
If you touch the Lamp use denatured alcohol and a soft cloth to clean it. If you do not
clean the Lamp the fingerprints will become etched into the glass which will diminish UV out-
put and may cause premature lamp failure.
Flush
Installation
Clip Connector
(Female)
Clip Connector
(Male)
Transformer Cap
Davis Connector
Quartz Cap
22. CONNECT THE LAMP:
Plug the Lamp
into each of the Clip Connectors located at the
end of the Harness. Make sure the Lamp is
plugged in all the way and flush with each of
the Clip Connector.
WARNING: Be careful when installing
the Lamp. If the Lamp is not plugged
in all the way this may cause damage
to the unit and is not covered under
Warranty, nor is any other damage
caused by improper installation.
21. INSTALLING THE LAMP:
Extend Lamp
Wires and insert into Quartz Sleeve. Position
Lamp so that the Clip Connectors are visible
on both ends of the unit.
MAINTENANCE
-
INSTALLING A NEW LAMP KIT CONTINUED
23.
Twist on transformer cap. Do not over tighten.
This is a connection only and is not in contact with
water.
24.
Tighten the Davis Connector located just
above the Transformer Cap.
25. FINAL LEAK CHECK
: Do not plug the Sterilizer into power yet, turn on the pump and check for leaks
again. For illustrations,
SEE PAGE 11
.
a. If you have a leak, return to Trouble Shooting Leaks on page 11. Carefully examine
this unit after installation. This unit should not be plugged in if there are any leaks on
any part of this unit.
b. If there are no leaks, turn power on.
Screw Ca
p
Screw Ca
p
NOTE:
Lamps and Quartz Sleeves should be handled with care. Lamps and Quartz Sleeves
are not warrantied against breakage and damage.
WARNING:
Do not install the Lamp at an angle (even a slight angle); this may cause a U
shaped crack at the end of the Quartz Sleeve, or possible breakage of the Lamp. If this
should happen, do not proceed with the installation. Purchase a new Quartz Sleeve or Lamp
from your dealer and refer to the proper installation instructions.
NOTE:
Do not force the Lamp into the Quartz Sleeve.
Summary of Contents for Viper SL 1200 Watt
Page 31: ......
