20
AQUA ULTRAVIOLET 42371 AVENIDA ALVARADO, TEMECULA, CA 92590 TEL: 951-296-3480 FAX: 951-296-3490
MAINTENANCE
- INSTALLING NEW LAMP KIT CONTINUED
12.
Check that the O-Ring is seated in both EZ-Twist Tops.
13.
Screw the EZ Twist tops on both sides of the Viper.
Hand tighten only. Do not use a pipe wrench, pliers or
any other tool.
14.
Center new quartz sleeve in housing (THIS STEP MAY REQUIRE TAKING THE UNIT OFFLINE TO
BETTER STEADY THE QUARTZ SLEEVE).
15.
Install both Rubber Seals until they touch the Inner Rim of the EZ Twist Cap. The Rubber Seal
should be 1/4" from each end of the Quartz Sleeve.
17.
Screw on the Quartz Caps at the same time mak-
ing sure not to pinch the Rubber Seal Bushing. Keep
equal amounts of the Quartz Sleeve on both sides.
Use extreme caution. DO NOT use a pipe wrench,
pliers or any other tool on this unit. Tighten by hand
only.
19.
Run Leak Test . Do not install lamp or electrical components yet. After the Quartz Sleeve has been
installed, turn on pump and run it for five minutes to check for leaks. If there are leaks see page 11 for
solutions.
20.
When there are no leaks install the lamp.
18.
If your unit does not have EZ Twist Tops, Place the
Rubber Seal Bushings on the ends of the Quartz Sleeve
on both sides of the Unit. Screw on the Quartz Caps at
the same time making sure not to pinch the Rubber Seal
Bushings. Keep equal amounts of the Quartz Sleeve on
both sides. Use extreme caution. DO NOT use a pipe
wrench, pliers or any other tool on this unit. Tighten by
hand only.
16.
Place the Rubber Seal Bushings on the ends of the
Quartz Sleeve above the Rubber Seal on both sides of
the Unit.
Summary of Contents for Viper SL 1200 Watt
Page 31: ......
