HOW TO...
REMOVE THE ROTATING SCRUBBING BRUSH
RETRIEVE CLEANER FROM POOL
ADJUSTING PORT EXTENSIONS
Should your cleaner have a Swivel:
Grab cable between the cleaner
and swivel. DO NOT grab swivel
GENTLY
pull the cable
and bring the cleaner
toward you.
Lift cleaner by using the handle
attached to the cleaner.
DO NOT lift cleaner by the cable.
1
2
3
CLEAN THE FILTERS
1
Grab the handle on the filter
basket and gently pull upward to
remove the baskets on each side.
Open the basket by using the
tab on the basket door.
4
Make sure to clean the inside
areas of the basket door.
3
Use a hose to clean out the
debris from the basket.
Spray into the basket from the
outside.
2
This model comes complete with a rotating
scrubbing brush located underneath the
cleaner. This brush is a moving part and is
powered by your cleaner. It is meant to pass
over surfaces and scrub as a an additinal
complimentary cleaning method.
This brush may be removed for easy
maintenance. This section shows you the
location and how to remove the brush.
Your cleaner is equipped with two adjustable suction ports on the underside
of the unit. Both can be lowered to maximize the suction strength for picking
up smaller debris. The suction ports are set to the lowest position by default.
To adjust the ports, use your hand to pull or push the extensions into place.
When you hear a click sound, this means the extension is locked into position
and ready. To change again, repeat the same action.