5
www.AquaProducts.com/Service
QUICK START INSTRUCTIONS
SETTING UP YOUR NEW ROBOTIC POOL CLEANER IS AS EASY AS 1, 2, 3!
NOTE: Models without Floating Handle, Floating Handles permanently locked parallel to cleaner body or models with a Handle
Float (Page 3; Fig. 1) around the Floating Handle do not require this step.
WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge!
IMPORTANT: Alternate the diagonal locked position of the Floating Handle with each use of your cleaner! This will help reduce
possible twisting of your Floating Cable and enable cleaning of any areas missed during the prior cleaning cycle!
Handle Spring Lock
(Version A)
Figure 5a
2 Diagonal Positions
Figure 5b
3 Diagonal Positions
Smaller angle allows slower movement when at waterline,
Larger angle provides faster movement.
Lock Floating Handle diagonally across cleaner body.
Handle Spring Lock
(Version B)
Handle Spring Lock
(Version A)
Power Supply
GFCI / RCD
outlet
Floating
Cable
Figure 5e
NOTE: Power Supplies with adjustable Timed Operation –
Please consult this operator manual for further instructions on
how to set its operating time and automatic shut down.
WARNING: A Ground Fault Circuit Interrupter (GFCI) / Residual Current Device (R.C.D.) must be installed to
protect your electric outlet and to prevent any possible electrical shock!
TIP!
To help protect your Floating Cable from potentially getting wrapped around your cleaner’s brushes, it is suggested to
turn off your pool’s filtration system while your cleaner is in operation.
NOTE: It is suggested to unplug the Power Supply when the
cleaner is not in use.
Power Supply
Floating Cable
12’ / 4m
from pool’s edge
Make sure that the power
supply is positioned and the
cleaner enters at the center
of the long side of the pool
Figure 5d
Figure 5c
NOTE: If your Power Supply features a Safety Reset Button
(Page 4, Fig. 4.26) to prevent unintentional, “out of water”
operation due to power surges or accidental pressing of the
Power Supply ON / OFF Switch – press the Switch to ON and
then press the Reset Button to start your cleaner.
Handle Spring Lock
(Version B)
