Aqua Phase,
A Division Mid-State Stainless Inc
. ●330 W Benson Ave. ●PO Box 228 ●Grantsburg, WI 54840 ●
USA
800-208-9274
●715
-463-
5851●FAX: 715
-463-
5853●
Email:
●WEB:
1.
Load the item
to be washed into wash chamber and close the front door.
For
Aqua Phase
units equipped with the Wheelchair Wheel Rotation System:
•
For washing wheelchairs - position the front, small diameter wheels into the
W
heel
C
arriage loading
rack, tip the wheelchair forward, and slide it into the wash chamber until the rear, large diameter
wheels rest between the
t
w
o
drive bars
closest to the door.
•
For washing items other than wheelchairs - it is recommended that you use the Equipment Rack for
easy loading, positioning, and unloading.
2.
Select the "
WASH TIME
"
(3, 5, or 7 minutes) on the control panel if your
Aqua Phase
is equipped with
variable
wash times. Choose the length of wash time based on the condition of the item to be washed.
3.
Set the "
RUN/DRAIN
" switch
on the control panel to "Run".
4.
Select the wash mode
("Clean & Disinfect", "Clean Only," or "Disinfect Only") on the control panel if your
Aqua Phase is equipped with the Disinfectant Application System.
5.
Push the "START" button
on the control panel.
Aqua Phase Wash Sequence Description
1.
The current status of the Aqua Phase system ("Wash cycle", "Rinse cycle", "Cycle complete", etc.) will be
shown
on the LCD display of the control panel.
2.
After pressing the "
START
" button, the computer will check to see if there is water in the water reservoir. If the
reservoir is not full of water,
Aqua Phase
will automatically fill to the appropriate level. The reservoir holds
approximately 5.5 gallons.
3.
When the reservoir is full, the pump will start and begin the wash cycle, spraying the item being washed.
AQ-240
Cleanin
g
Solution
is automatically injected shortly after the wash cycle begins.
4.
The Aqua Phase will now be in the wash phase, and will continue for the wash time selected of 3, 5, or 7
minutes.
5.
When the wash phase is complete, the dirty wash water will be pumped out of the
Aq
ua Phase
to the drain.
6.
Aqua Phase will automatically refill to the appropriate level with fresh water.
7.
After the reservoir is filled with water, the pump will start and the Aqua Phase will begin the rinse phase. The
AQ-260 R
inse
A
gent is automatically injected shortly after the rinse phase begins. The rinse cycle will last for
approximately 90 seconds.
8.
The disinfectant application cycle will
automatically be
g
in
if
CLEAN
&
DISIN
F
ECT
w
as selected.
(If the
Option was purchased.)
During normal automatic operation, the rinse water remains in the machine and will be the wash water for the next
item placed in the chamber. If you choose, you may drain the rinse water prior to beginning the next wash cycle. To
drain the machine manually:
Set the "
RUN/DRAIN
" switch to "
DRAIN".
Push the "
START
" button. The machine will drain the water.
Prior to beginning the next wash cycle, set the "
RUN/DRAIN
" switch to "
RUN
".
When the next wash cycle begins, the machine will automatically fill with fresh water for the wash phase.
OPERATING PROCEDURES &
WASH SEQUENCE
13
