8
back
bow
Fig.2
Tip:
It's better to inflate the boat about 20% before plywood deck installation.
a. Start by fitting the wooden bow board between the air tubes and bottoms. Push it forward as
far as possible until it reaches the top of the bow (Fig. 2) and the air valve of the inflatable floor
fits into the hole of the stern wooden board. Fit the back board to the rear end. (Fig.3)
c. Step on raised part of two connected floor sections and push down the two boards at the joint.
Make sure the deck is flatten by spreading inside the boat (Fig 4).
Fig.3
b. Lift the middle section a bit and create a roof-like structure.(Fig.3)
Fig.4
Fig.5
Fig.1
e. Inflate the left and right tube of the boat firstly and then inflate bow section of the boat. Finally,
inflate the keel. Use hand pump to finish.
WOOD DECK INSTALLATION
1. BT-88850
BT-88850 is equipped with a foldable floorboard system. (Fig. 1)
