STEP 3: WALL INSTALLATION
Measure
3.1: Before installing the wall, use a flexible tape measure to measure the perimeter of the wall. Measure by
inserting the tape measure into the bottom wall channels around the pool and compare it with the table PART
LIST in the ANNEX under the name Steel wall (Hole-to-Hole).
NOTE 1: If the measure is smaller than the length of the wall, distance the bottom wall channels in the bottom
joining plates (round section). If the measure is greater than the wall, close the distance of the bottom wall
channels in the bottom joining plates (round section).
Installation
NOTE 1: During installation, make sure the wall in the round section is held in place using rope and stakes
planted in the ground. Also, install top wall channels temporarily to keep the wall in place.
NOTE 2: The wall installation starts where the water return and the skimmer are to be placed. In addition, it is
important to start the wall installation on a bottom plate, when the wall is closed a support post will hide the
wall junction.
NOTE 3: Also, you need to carry sand in the middle of the pool if you plan to build a cove and bottom
protection for the pool.
3.2: Put the wall on a solid surface to facilitate unfolding.
3.3: Insert the wall starting in the center of a bottom joining
plate.
7
