Sand cove
5.1.2 - A: Make sure that the cove is at least 3 inches high
along the wall and ends in a gentle slope towards the interior of
the pool. Be sure to compact the sand and remove any small
stones.
OR
Styrofoam cove
5.1.2 – B: Place the preformed cove around the base of the
pool wall. Use duct tape to attach the cove along the wall.
Step 5.2: LINER INSTALLATION
5.2.1: Place the folded liner in the center of the pool. Unfold
the liner making sure that the printed texture is facing up. Also
bring the bottom seam along the base of the pool wall, once
extended the liner should be at +/- 4 inches from the wall
(remove shoes to avoid damaging the liner).
IMPORTANT :
Do not cut skimmer and return holes until there is 2 feet (60 cm) of water in the pool.)
Step 5.2.2 - A: Beaded liners and “snap-in” installation
If you don’t have this type of liner, jump to the next section!
5.2.2 - A1: Remove the top wall channels one section at a
time.
13
