Copyright © 2021 Aqua Creek Products All Rights Reserved
Revised 5/28/21
PROCEDURE
BEFORE
EACH USE
DAILY WEEKLY MONTHLY
Check battery level indicator on control box
Run the lift through a complete test cycle (fully
extend actuator) to verify it is functioning properly
Wash lift with fresh water and dry with clean, soft,
non-abrasive cloth
Recharge battery
Visually inspect lift for damage, corrosion, and loose
or missing hardware
Check all contact points for damage and/or corrosion
Repair, clean and apply dielectric grease to all contact
points
Thoroughly clean lift frame and apply a liberal coat of
car wax to maintain the lift’s finish
Check all Warning and Cautionary labels to make sure
they are not faded or worn. Replace as needed.
Proper Care of Pool & Spa Lifts
PROPER CARE NOTES
• Use only fresh water to wash your lift. Do not wash with pool water.
• Use only clean, soft, non-abrasive cloths on your lift.
• Do not store lift in pump room or near chemicals.
• Do not allow children to play on or around this lift.
• When cleaning the lift, do not spray water directly on control box or battery.
• The lift may need to be bonded according to local code requirements.
• If the lift is not used for extended periods, remove the battery from the lift and store it
on the wall charger to maintain the batteries charge. The charger should be plugged in
and in a climate controlled area.
For service and/or replacement parts, contact Aqua Creek Products
Toll free: (888) 687-3552
To remove stubborn stains from finish, spray affected area with mild dish soap, rub
briskly with a 3M Scotch Brite™ pad. Use white epoxy paint to touch up the finish. Apply
wax to protect when dry.
STAIN REMOVAL TIPS:
10
