Portable filtration units
15
11 ELECTRICAL CONNECTION ON MAXIROLL / MAXICART
Note on MAXIROLL electrical:
standard unit is supplied with a 115V starter, 15’ power cord with
a 3 prong plug. If other voltage is ordered, plug will be supplied by customer.
Note on MAXICART electrical:
unit is supplied as per required voltage and 15’ power cord. Plug
will be supply by customer.
1.
Plug the unit into a proper electrical outlet.
2.
If you need to use an electrical extension cord, ensure the cord meets the requirements for
the motor amperage.
3.
Ensure you do not move the unit further than the length of the cord. This could result in
breaking or ripping the cord and cause an electrical shock.
12 PERFORMANCE
12.1 Check list
Before starting the unit for the first time, the check list listed below must be followed to ensure
all components work properly.
1.
Remove all objects around the fume arm hood.
2 .
Ensure access door is closed and locked.
3.
Ensure power cord is connected into an appropriate electrical outlet.
4.
Start the unit and shut it off immediately. Listen for unusual noises coming from the motor
or impeller.
5.
Start the unit again and let it run for a few minutes before using it as per it’s required
application.
12.2 Performance instructions (pulse cleaning system)
1.
Plug the unit into a proper 120 VAC outlet. Turn the selector knob to the ON position. (See
figure 3)
2.
Positon the fume arm hood about 10" to 15" (250 à 380 mm) away from the welding gun or
source of dust.
12.3 Compressed air cleaning
Note :
a check valve should be tapped onto the 1/4" NPT connection before filling the
compressed air tank. Air should be clean and dry.
WARNING!
Do not operate the pulse cleaning system when filter access
door is opened.
