APV ISOBUS M2, Operating Manual

Page: 43 / 56

43
9.3 WARNINGS - TC "AUTO" MODE
Warnings when the implement is in the Task Controller AUTO mode:
Display Cause Solutions
TC units inconsistent! The units for the specified
values from the Task Controller
do not match the expected
units.

TC units must be verified.
TC specifications no longer
available! The TC specification is no
longer available on the tractor
side.

Check the Task Controller.
TC specifications will be used! The TC specification will be
used, it only serves as
information.
9.4 ERRORS
Display Cause Solutions
Operating voltage not OK!

The supply voltage is below
8 V.

Excessive voltage
fluctuations.

Minimise consumers (e.g.
switch off the work
floodlights).

Check the battery.

Check the cabling.

Check the plugs.

check the alternator.
Motor is overloaded (seeding
shaft I)!
Motor is overloaded (seeding
shaft II)!

A seed shaft is not able to
rotate.

The motor has been
strained too long at its
limits!

Switch off the control box!

Remove any foreign objects
or similar from the seeding
shaft or the agitator.

Switch off the agitator (with
well-flowing seed).

Remove 1-3 spacing discs
from the seeding shaft.

Check the set motor type.

Check the idling motor for
proper function.

Refer to the seeder
operating manual
Error (fan)!
Only with electric fan:
Is displayed when the
implement cable is not
connected or the cabling is
faulty.

Check the cabling.

Check the plug on the
motor module.

Read the error message on
the motor module (motor
overloaded or motor not
connected) and fix the error
according to the seeder
operating manual.