23
Quality for Professionals
The table shows the settings for slug pellets:
Slug pellets
Working width
Throwing vane I
Throwing vane II
<20m
Point 1
Point 1
20m
Point 2
Point 2
24m
Point 3
Point 3
28m
Point 4
Point 4
The following general rule applies for all seed types: if the spreading density is higher in
the outer area than in the middle, the throwing vanes must be adjusted further towards
"Point 1".
NOTE:
The slider is only opened when the spreading plate is rotating.
10.5 Point of impact adjustment
The point of impact adjustment can be used to adjust the entire spread pattern by 20° in
both directions. This can be important for some spreading materials, e.g. to avoid
having to adjust the throwing vanes. For example, if the spread pattern is turned by 15°
to the right, the point of impact adjustment is turned by 15° to the left. If you move it
further to the right, a boundary spreading function can also be obtained.
Fig.: 14
Fig.: 15
