14
Quality for Professionals
8.4
Attachment of the control box
Fasten the standard supplied bracket in the
tractor cab with two bolts. Stow the excess
cable in the driver's cab to avoid pinching.
TIP:
Pay attention to the angle at which you
look at the control box to be able to read the
display optimally. If necessary, bend the
bracket slightly to adjust the angle as required.
8.5
Electrical connections
The standard supplied cable can be directly connected to the 3-pin standard socket in
the cab. The other end is connected to the control box.
The 4-pin cable from the control unit is also connected to the control box.
The fuse (20 A) is located on the right side of the control box.
TIP:
If your tractor or towing vehicle does not have a 3-pin standard socket, you must
perform the wiring yourself to the battery.
To do so, you need a cable (motor vehicle cable set (3m), item no.: 00410-2-027 or
tractor cable set (8m), item no.: 00410-2-022), which you can purchase from us as an
accessory, see Points 15.5 and 15.6.
The cable routing is performed as follows:
The cable (motor vehicle or tractor) is screwed directly on the terminals of the battery on
the battery side, and at the other end, a 3-pin standard socket is installed.
CAUTION:
If these instructions are not observed, damage may be caused to the control
box!
IMPORTANT NOTE:
For safety-related reasons, disconnect the controls after using the
implement!
Fig.: 6
