- 34 -
R
I n s t a l l a t i o n
4
English
Information
Do not tighten the clutch screws (8); this enables you
further adjustments. Tighten the screws only at the
end of the installation.
Information
Caution
4.1.1 Installing the geared motor
According to the type of shutter, the following brackets
can be assembled to the geared motor (1):
≠
curved brackets (standard supplied);
➂
articulated brackets (upon request).
•
When using the curved bracket (2), assemble it with
the relevant sliding block (4) using the hexagonal head
screw M6x20 (5).
Information
The sliding block (4) shall rotate without efforts; it is
recommended to tighten screw (5), then loosen it by
1/4 turn.
1
6
3
9
2
7
2
4
5
3
AP009024
AP009025
10
10
AP009021
AP009022
AP009023
AP009026
8
•
Assemble the geared motors to the supporting rail
using the hexagon socket screws M5x80 (10). Pay
special attention to the orientation of the geared
motors. It shall be as shown in the figure.
•
Close the shutter wings.
Pay particular attention to the orientation of rings (6),
(7) and the rotation direction of the bracket (right or
left).
Do not tighten the locking screws (10) to allow the
geared motors to slide along the guides.
OUTSIDE
INSIDE
OUTSIDE
INSIDE
Curved brackets
Articulated brackets
Single-wing
Double-wing
