Aprimatic ADI R230E, Instructions Manual

Page: 12 / 28

Keys-Commands confi guration
With these assignments, the transmitter will send the following commands:
11. CENTRALIZED CONTROL - VIA RADIO
The easiest way to control more automatic systems via
radio is to store
the same remote control in all modules
you wish to operate together. In this case whether
you add a remote control to the system, dedicated to
the simultaneous control or you lose the possibility
to control the automations individually. Additionally,
the commands transmitted by the dedicated remote
control will not have priority.
A more effi cient way to control more automations simultaneously, using the peculiar characteristics of the modules,
is programming them in order to receive “Centralized Activation” and “Centralized Deactivation” commands. In
this way, you get prioritized centralized commands as well as the possibility to simultaneously control more loads
individually and by group with one remote control.
Centralized commands have priority on local commands: for the entire duration of a centralised command,
local commands will remain disabled.
When a “Centralised Deactivation” command is given, loads will be turned off immediately regardless of their
state and the selected functioning logic.
When a “Centralised Activation” command is given, the connected loads will be turned on immediately. The type
of functioning will depend on the selected functioning logic -i.e. in the “ON/OFF” mode, loads will remain activated
for an indefi nite time, in the timer mode, loads will remain powered up for the pre-set time duration, and in the “dead
man” mode, activation will remain on as long as the signal is transmitted.
Example 1 : individual or multiple control of two loads with one 4-key remote control.
Assign the following positions to the radio commands.
With these assignments, the transmitter will send the following commands:
Radio command M1 M2 M3 M4 M5 M6
Channel 1 Command T1 T3 T5 T7 T9 T11
Channel 2 Command T2 T4 T6 T8 T10 T12
Centralized Activation T13 T13 T13 T13 T13 T13
Centralized Deactivation T14 T14 T14 T14 T14 T14
Example 2 : individual or multiple control of 12 loads (C1, C2, ..., C12) with six modules (M1,M2,..,M6) with one
14-key remote control (T1,T2,T3,..,T14).
Assign the following positions to the radio commands.
Assignments
Channel 1 Command Key 1
Channel 2 Command Key 2
Centralized Activation Key 3
Centralized Deactivation Key 4
Module 1
Channel 1
Command
Centralized
Activation
Channel 2
Command
Centralized
Deactivation
Command C1 Command C2 Command C3 Command C4
Command C5 Command C6 Command C7 Command C8
Command C9 Command C10 Command C11 Command C12
Centralized
Centralized
Activation Deactivation