125
use and maintenance
RSV 1000 R
- RSV 1000 RFACT
USA
USA
To remove the side stand:
X
Remove the left side cover, see p. 119
(REMOVING THE SIDE PANELS).
X
Lift the fuel tank, see p. 117 (LIFTING
THE FUEL TANK).
NOTE
Obtain a tie-wrap (7) to use for
reassembly.
CAUTION
Do not force cables, tubes, lines,
connectors and wires.
X
Cut the tie-wrap (8) and release the
cable (9).
X
Disconnect the electric connector (10)
from the connector (5).
X
Withdraw the cable (9) completely.
X
Lower the fuel tank, see p. 117 (LIFTING
THE FUEL TANK).
NOTE
Support the stand, in order to
prevent it from accidentally falling down.
Torque wrench setting for screws (11)
and (13): 40 Nm (4 kgm).
X
Unscrew and remove the screw (11) and
collect the washer (12).
X
Unscrew and remove the screw (13)
while holding the nut (15) at the rear end
with a wrench.
X
Remove the stand (1) complete with:
– springs (2);
– bracket (3);
– stand switch (4).
X
Refit the screw (13), the washer (14) and
the nut (15) and tighten to the specified
torque.
7
9
14
13
12
11
15
Summary of Contents for RSV 1000 R - 2003
Page 1: ...8104704 RSV 1000 R RSV 1000 R FACTORY ...
Page 21: ...safe drive ...
