APRILIA RALLY 50, Manual

Page: 84 / 104

84 use and maintenance Rally 50
-
#(!.').'
4(% (%!$,)'(4 "5,"3
Carefully read p. 83 (BULBS).
The headlight contains:
– one parking light bulb;
– one low/high beam bulb.
To change the bulbs:
◆
Remove the front inner shield, see p. 73
( R E M O V I N G T H E F R O N T I N N E R
SHIELD).
◆
Pull back the rubber boot (1) with your
fingers.
PARKING LIGHT BULB
a
CAUTION
While removing a bulb socket, do not
pull on the wires.
◆
Grasp the bulb socket, pull it and remove
it from its seat.
◆
Remove the parking light bulb and re-
place it with an identical bulb.
LOW/HIGH BEAM BULB
◆
Rotate the check tang.
◆
Remove the low/high beam bulb and re-
place it with an identical bulb.
#(!.').' 4(% &2/.4 !.$ 2%!2
$)2%#4)/. ).$)#!4/2 "5,"3
Carefully read p. 83 (BULBS).
NOTE
Before changing a bulb, check
the fuse, see p. 80 (CHANGING FUSES).
◆
Place the vehicle on the center stand.
◆
Unscrew and remove the screw (2).
NOTE
While removing the lens, use ex-
tra care to be sure that you do not break
the key.
◆
Remove the lens (3).
NOTE
Upon reassembly, position the
lens correctly in its seat.
a
CAUTION
Tighten the screw (2) moderately and
with care to avoid damaging the lens.
◆
Push the bulb (4) in slightly and rotate it
counterclockwise.
◆
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
carefully aligning the two bulb pins with
their guides in the socket.
◆
Correctly install a new bulb of the same
type.
NOTE
If the bulb socket (5) has fallen
out of its seat, replace it correctly, ensuring
that the slot in the reflector aligns with the
screw hole in the body of the turn signal
lamp.