13
4
、
Microsoft Internet Explorer
4.1
Connecting the IPNetcam
1.
Start up the Microsoft Internet Explorer, and then follow the steps below to connect the IPNetcam.
2.
Click the URL block at the top of the window.
3.
Enter the URL address of the IPNetcam into the URL block and press the “
Enter
”
button to enter the
home page.
4.
Scroll to the bottom of the page, with its five icons, "Image", "Network", "System", "Application" and
"SD card". Whichever you click, the page headlined "Enter Network Password" will appear.
5.
Type in the "User Name" and "Password" in the appropriate spaces.
6.
Click the “
OK
” button to set your entries, and automatically exit the page.
NOTE:
The default "User Name" and "Password" are admin and 9999 respectively.
NOTE:
The page headlined "Enter Network Password” is shown below. Please enter the user name and
password of the IPNetcam when you see it. If either the user name or the password is incorrect, please
check the input data and rectify it if necessary.
NOTE:
Once authorized successfully, it will not appear again until you close the window and reconnect it.
NOTE:
The initial sequence of proceeding is to type in your IP address and click the "
Enter
" button to
access the home page. If and when you revise or change data in the "
SYSTEM USERS
" page, the
sequence will alter to initially show the "
Enter Network Password
" page.
Browsing images from the IPNetcam
The images from the IPNetcam will be displayed on the home page while going online with the IPNetcam.
Some buttons of the home page are provided for further setting.
Homepage of MPEG4 mode
