A product of Applied Membranes, Inc.
www.appliedmembranes.com
A product of Applied Membranes, Inc.
www.appliedmembranes.com
Page 2
Page 3
Getting Started - Your package contains:
PuroSmart System (with RO Membrane &
Carbon/Sediment Pre-Filter inside)
Flow restrictor Assembly with White Tubing
Diverter Valve (with Gasket & White Tubing)
2.5’-foot Long Section of Clear Tubing
Plastic Stand with Mounting Clip & Hardware
Installation
Note: PuroSmart uses quick-connect
fittings. To make a connection, ensure
the tubing is fully inserted all the way to
the tube stop. Pull the tube to check it is
secure.
To disconnect tubing, push the collet
square against the fitting. With the collet
held in this position, the tube can be
removed.
Step 1: Remove the aerator from the
kitchen sink faucet.
(Figure 1)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Step 2: Place the gasket into the
diverter valve and screw the assembly
onto the faucet.
(Figure 2)
Step 3: Assemble the plastic stand
(Philips-head screwdriver required) and
mount the PuroSmart.
Step 4: Install the 2.5’ clear tubing into
the connector on the top right side
connection of the PuroSmart.
(Figure 3)
Step 5: Remove the blue locking clip
then connect the Diverter Valve Tubing
into the connector at the top of the
PuroSmart, then re-install the locking
clip.
(Figure 4)
Step 5: Place the system in the sink,
turn the diverter valve knob to the
horizontal position, and run cold water
to flush the PuroSmart for a few seconds
before installing the flow restrictor.
Step 6: Turn off the water and install
the Flow Restrictor Assembly. Push the
flow restrictor assembly elbow into the
connection at the bottom of the
PuroSmart.
(Figure 5)
Step 7: You are now ready to begin
making water. You must run your
PuroSmart for 2 hours and discard the
first amount of water produced in this
period. Using a storage container, you
can collect water made by the
PuroSmart any time you need water.
PuroSmart System Diagram
Maintenance
Your PuroSmart RO System was designed to be
virtually maintenance free. Simply follow these
recommendations and your PuroSmart should last for
years.
To protect the RO membrane, the carbon block
pre-filter should be replaced every 3 months or
400 gallons of treated water.
To ensure the highest quality drinking water,
replace the RO membrane every 12 months.
When not in use, your PuroSmart can be
disconnected, placed in a plastic bag, and
stored in the refrigerator.
Replacement Parts
Carbon Pre-Filter
(3-Pack)
502025-3
RO Membrane
15 GPD: 502026
50 GPD: 502026-HF
Flow Restrictor
15 GPD: 502036
50 GPD: 502036-HF
Diverter Valve
502275
Feed Connector
200476-1
Head Assembly
502211
Pre-Filter O-Ring
502003
Sump Vessel
502267
Sump O-Ring
502001-2
Feed Inlet O-Ring
500205
