4
SECTION 2
RECEIPT AND INSPECTION OF THE CHARGER
Upon receipt of the charger, the information on the shipping carton should be checked against
your order. All chargers can be handled with a lift truck by inserting the forks under the bottom
of the charger. Remove the carton and inspect the charger for damage. If there is any damage,
save the carton for inspection and notify the carrier immediately. Check the nameplate & labels
against your order & specifications. Any discrepancies should be reported immediately to the
nearest Applied Energy Solutions authorized representative.
SECTION 3 INTRODUCTION
The Maverick Industrial Battery Chargers are High Frequency chargers utilizing Insulated Gate
Bipolar Transistor technology. This charger is designed to output high rate current charge of
18A/100AH for standard charging applications.
SECTION 4
CONTROL FEATURES
Delayed start from fifteen minutes to two and one quarter hours in fifteen minute intervals
Equalize can be done manually or automatically if battery is left connected (every 5 cycles)
Automatic 12-hour refresh (selectable on/off)
Remote Control Inte
rface for use when mounted above operator’s reach
Auto start with five second delay
Stackable without brackets
Manual jump start for over-discharged batteries
Full load power factor of 0.95
Automatic shutdown for the following:
o
80% or final charge exceeds time limit
o
Volts per cell outside safe limits
o
Charging current too high or too low
o
Charger internal temperature outside of specification
Digital readout displays:
o
Charge current/voltage
o
Equalize in process
o
Fault codes
LED charge status indicators
o
Charging
o
80% Charged
o
Charge Complete
o
Equalize
o
Refresh
o
Fault Shutdown