97
EN
1. Connect the red test lead to "µAmA" terminal and
the other (black) test lead to "COM" terminal, or use
the "A" and "COM" terminal in the 20A range.
2. Set function selector rotary switch to "µA" or "mA"
or "A".
3. Measurement of AC current can be performed by
pushing the "AC/DC" switch.
4. Connect the test leads to the circuit to be measured.
3-3 Current Measurement
1. Connect the red test lead to the " V Ω
" input
terminal and the other (black) test lead to the "COM"
terminal.
2. Set the rotary function to the ACV or DCV position.
3. Connect the test leads to the device to be measured.
3-2 Voltage Measurements
WARNING
TO AVOID ELECTRICAL SHOCK , HAZARD OR
DAMAGE TO METER , DO NOT A ATTEMPT TO
MEASURE VOLTAGE THAT MIGHT EXCEED 1000
VOLT DC OR 750 VOLT AC . DO NOT APPLY MORE
THAN 1000V DC OR AC RMS BETWEEN THE
COMMON INPUT TERMINAL AND EARTH GROUND.
NOTICE :
UNSTABLE DISPLAY MAY OCCUR
ESPECIALLY AT 300mV RANGE , EVEN THOUGH YOU
DON'TPUT TESTED LEADS INTO INPUT TERMINALS.
IN THIS CASE , IF AN ERRONEOUS READING IS
SUSPECTED, SHORT THE " V Ω
" TERMINAL AND
THE "COM" TERMINAL, AND MAKE SURE
THE ZERO DISPLAY.
3. If the equipment is used near noise generating
equipment, be aware that display may become
unstable or indicate large errors.
4. Maximum rated voltage to earth for voltage and
current measurements terminals is 1000V AC / DC
CAT. II .
8
