Apollo MultiSpot HQ5020, User Manual

Page: 16 / 28

User Manual: Multispot GII-HQ5020
V2.00 (08-2015)
12
7) Remove the 5 standoffs that define the lens panel distance to the PCB by
unscrewing them with left-turns. Keep these 5 standoffs stored together with
the removed lens panel as every specific lens panel has its matching standoff
length.
8) Insert the 5 standoffs that have been delivered with the new lens panel into the
relative thread holes and fix them properly with right-turns.
9) Put the new lens panel into place by perpendicularly lowering it down on the
LED panel. Make sure the LED panel is lowered in the right position, as
lowering it in the wrong position may lead to collision between the lenses and
the LEDs, which may damage the LEDs.
10) Put the 5 lens panel screws back into place which hold the lens panel and
tighten them with 0.50-0.55Nm torque.
11) Check whether the front glass seal smoothly surrounds the front glass in
proper position and put the front glass back into place, properly centering it on
the mounting edge around the Lens/LED panel.
12) Check whether the main seal is properly aligned and smoothly adapts to the
groove around the lens/LED panel.
13) Carefully lower the front frame down on the main unit in the right position with
aligned screw holes, avoiding any position change of the front glass with seal
and the main seal during this procedure.
14) Provide clamping of the main unit and the front frame by means of holding
them together with both hands, and turn the unit around.
15) Put the 8 screws back into place which connect the main unit with the front
frame and tighten them with 3.0-3.3Nm torque.
16)
User Manual: Multispot GII-HQ5020
V2.00 (08-2015)
13
■ Getting started: choosing a location
Risk of fire:
The MULTISPOT-GII-HQ5020 LED has been designed for
environmental temperatures of up to 40 degrees Celsius. For proper
operation, the unit must be operated with unobstructed air convection to
its outside metal case.
Do not:
 Operate the MULTISPOT-GII-HQ5020 LED in environments with more than 40
degrees environmental temperature
 Operate the MULTISPOT-GII-HQ5020 LED in any closed environment smaller
than 10cbm, unless forced air convection is provided.
■ Getting started: secure mounting
The MULTISPOT-GII-HQ5020 LED can be mounted in various ways:
Floor standing operation
 Turn the bracket to the lower side of the unit and fold out the second, inlaying
bracket.
 Place the unit in a secure position where it can neither be touched by anyone or
could possibly become an objective for anyone to stumble.
 Make sure to comply with cooling requirements of the used power supply if any.
Hanging/Rigging, ceiling-mounted operation
Risk of injury:
Overhead mounting requires extensive experience, like
calculating working load limits, knowledge installation materials, and
periodic safety inspection of all installation material and the unit. If you
lack such qualifications, do not attempt the installation yourself.
Improper installation can result in body injury. Be sure to complete all
rigging and installation procedures before applying power to the unit.
 Leave the inner and outer bracket folded.
 The unit should be installed out of reach of people and outside areas where
persons may walk by or be seated.
 Make sure that the installation area can hold a minimum point load of 10 times the
device’s weight.
 In fixed installations, fix the unit with self-locking screws/nuts to the mounting point.
 When mounting the unit to truss be sure to secure an appropriately rated clamp to
the hanging yoke using a M10 screw fitted through the center hole of the hanging
yoke.
 Where required, secure the installation with an appropriate safety cable. Always
use a certified safety cable according to DIN56927 that can hold 12 times the