Apollo AGB50MKA37RXF6, User Manual

Page: 70 / 82

70
After changing the idling jet, start from the beginning with the adjusting steps.
Following extreme air temperature or altitude changes, adjust the idle speed again.
If the speed rise is too high, reduce the idle speed to a normal level and repeat the preceding
steps.
If the procedure described here does not lead to satisfactory results, the cause may be a
wrongly dimensioned idling jet.
If you can turn the idle adjusting screw to the end without any change of engine speed, you
have to install a smaller idling jet.
12.5 Checking the engine oil level
Preparatory work
• Stand the motorcycle upright on a horizontal surface.
Condition
The engine is cold.
• Check the engine oil level.
The engine oil reaches the middle of oil gauge or oil sight.
If the engine oil does not reach the middle of the level
viewer A:
• Add engine oil. ( .72)
Condition
The engine is at operating temperature.
• Check the engine oil level
The engine oil level can be checked when the engine is cold or warm.
After switching off the engine, wait one minute before checking the level.
A
12.6 Changing the engine oil and oil filter, cleaning the oil screens
Danger of scalding
Engine and gear oil get very hot when the motorcycle is ridden.
• Wear suitable protective clothing and safety gloves.
• In the event of scalding, rinse the area affected immediately with lukewarm water.
Danger pour l’environnement
Hazardous substances cause environmental damage.
• Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in com-
pliance with the applicable regulations
Drain the engine oil while the engine is at operating temperature.