Page 16 code HG0109.12GB ed.C-1106 rev.12
APEN GROUP reserves the right to change products and documents as required.
WARM AIR HEATER SERIES RAPID
Filter
Fireproof
Power
connection
cable
ASSEMBLING EASED FRAME AND ACCESSORIES
In order to assemble the heater to eased frame, fan compartment
shall be mounted on the heater using supplied screws (see figure).
To fasten shutters or filters to eased frame, tighten M8 screws
supplied in the kit to the nuts on eased frame. To fasten filters
to the shutter, both nuts and M8 screws are needed.
WIRING THE EASED FRAME
Inside burner compartment, a relay is already wired to wiring
card. The wire from eased frame shall be wired to this relay
as described in the figure. No problem if brown and grey wires
are reversed.
Contact NO
14-5
Contact
44 -8
Gray wire
(Neutral)
Brown wire
(Phase)
Yellow/green wire
(Ground)
Wire from
eased frame
Connection from the card
to A1- A2 terminals of the
relay
(already wired)
code X01061
code X01076
(230V)
