4
CAUTION:
Improper usage can cause serious injury to personnel
and/or damage to equipment and work area. For your own safety
please observe the following precautions.
SAFETY PRECAUTIONS
●
Check each component after opening the package to make sure
everything is in good condition. If there are any suspected
damage, do not use the item and report the issue to your vendor.
●
Do not strike or subject the unit to physical shock. Use carefully
to avoid damage to any part.
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
●
Tip temperature may reach as high as 400°C when switched ON.
- Do not use the device near flammable materials.
- Do not touch heated parts, which can cause severe burns.
- Do not touch metallic parts near the tip.
●
Disconnect the plug from the power after use.
●
Melting or retouching plastics produces smoke, use on well
ventilated places.
●
Do not alter the unit, specifically the internal circuitry, in any
The manufacturer declines all responsibility for any damage caused by
incorrect or unreasonable use, such as:
●
Improper use by untrained persons;
●
Technical modifications or operations not recommended by the
manufacturer;
●
use of non-original or non-specific spare parts;
●
failure to follow the instructions given in this manual.
25
OPERATING GUIDELINES
ADVANCED OPTIONS II
Within the advanced options selection we can also set
the PLA Mode temperature , ABS Mode temperature, and the
Single set temperature mode temperature.
PLA Mode temperature : default value is 200.
ABS Mode temperature : default value is 250.
Single Set temperature Mode : default value is 225.
From off to Mode Lock Selection
Press and hold
UP & DOWN button
while plugging in the
tool
Pass code entry mode
Pass code is now at 110
(UP button pushed until it reaches code 110)
Pass code correct, now in selection 1
(UP and DOWN button simultaneously pushed)
4
CAUTION:
Improper usage can cause serious injury to personnel
and/or damage to equipment and work area. For your own safety
please observe the following precautions.
SAFETY PRECAUTIONS
●
Check each component after opening the package to make sure
everything is in good condition. If there are any suspected
damage, do not use the item and report the issue to your vendor.
●
Do not strike or subject the unit to physical shock. Use carefully
to avoid damage to any part.
- Never drop or sharply jolt the unit.
- Contains delicate parts that may break if the unit is dropped.
●
Tip temperature may reach as high as 400°C when switched ON.
- Do not use the device near flammable materials.
- Do not touch heated parts, which can cause severe burns.
- Do not touch metallic parts near the tip.
●
Disconnect the plug from the power after use.
●
Melting or retouching plastics produces smoke, use on well
ventilated places.
●
Do not alter the unit, specifically the internal circuitry, in any
The manufacturer declines all responsibility for any damage caused by
incorrect or unreasonable use, such as:
●
Improper use by untrained persons;
●
Technical modifications or operations not recommended by the
manufacturer;
●
use of non-original or non-specific spare parts;
●
failure to follow the instructions given in this manual.
25
OPERATING GUIDELINES
ADVANCED OPTIONS II
Within the advanced options selection we can also set
the PLA Mode temperature , ABS Mode temperature, and the
Single set temperature mode temperature.
PLA Mode temperature : default value is 200.
ABS Mode temperature : default value is 250.
Single Set temperature Mode : default value is 225.
From off to Mode Lock Selection
Press and hold
UP & DOWN button
while plugging in the
tool
Pass code entry mode
Pass code is now at 110
(UP button pushed until it reaches code 110)
Pass code correct, now in selection 1
(UP and DOWN button simultaneously pushed)
