10
OPERATING GUIDELINES
C. VACUUM PICK UP PEN (FOR Int 852A++ only)
1. Connect the vacuum pick up tool to the vacuum pen connector (“H”
form the control panel guide).
2. Make sure the Hot Air gun function switch is in the off position.
3. Select the appropriate vacuum pick up head and attach to the
vacuum pick up tool.
4. Simultaneously press the air pressure control up and air pressure
control down button (“C3 and C4” from the control panel guide).
This will activate the vacuum pick up mode.
5. During the vacuum pick up mode the display “B2” will show the
word “VAC” indicating it is currently in the vacuum pick up mode.
6. Us the vacuum pen to pick up small components, Place the tip of
the vacuum pen on top of the component, cover the hole found on
the vacuum pen to pick up the component.
7. To drop the component down, uncover the hole on the vacuum pen.
8. To deactivate the vacuum pick up mode. Simultaneously press the
air pressure control up and air pressure control down button (“C3
and C4” from the control panel guide).
D. System Settings
The device has a system settings menu which can be access by
following the procedures below:
1. Turn off unit.
2. Ensure that the Hot Air gun function switch “F” is in the ON position.
3. Power ON unit by switching the power switch to ON.
4. While the “AOYUE” name is scrolling simultaneously press and hold
both temperature control up and down button (C1,C2).
5. If successful the display would show “SEL 1” indicating that the
system settings menu has be accessed.
6. Adjust selection menu with the air flow control down button “C4”.
7. Selection menu is adjustable from 0 to 7. To enter the selected
function, press the hot air gun function switch.
7
As soon as the equipment has been removed from the package,
REMOVE THE SCREW located at the center of the bottom of the
main unit. This screw holds the pump in place during transportation.
Hot Air Gun holder was installed on the station upside down for
packaging purpose.
To set up the Hot Air Gun holder:
1. Loosen the two screws that secure the holder to the station.
2. Turn the holder right side up.
3. Re-fasten the two screws.
4. Place the hot air gun onto the holder in preparation for usage.
ASSEMBLY and PREPARATIONS
WARNING:
Failure to remove the screw before using the
equipment can cause damage to the system.
Loosen the two screws
that secure the holder to
the station.
Turn the holder
right side up.
Re-fasten the two
screws.
