![background image](http://html1.mh-extra.com/html/aoyue/int-852a-pro/int-852a-pro_instruction-manual_2951576003.webp)
14
BASIC TROUBLESHOOTING GUIDE
PROBLEM 1: THE UNIT HAS NO POWER
1.
Check if the unit is switched ON.
2.
Check the fuse. Replace with the same type if fuse is blown.
3.
Check the power cord and make sure there are no disconnections.
4.
Verify that the unit is properly connected to the power source.
PROBLEM 2: HOT-AIR GUN TEMPERATURE DISPLAY IS ALWAYS ABOVE 500
o
C
Description: Constant display of above 500
o
C temperature
from the panel then displays an
“OFF” on the panel after a few minutes.
SOLUTION:
The thermal sensor may be broken and needs to be replaced.
PROBLEM 3: HOT-AIR GUN ACTUAL AIR TEMPERATURE IS NOT INCREASING
Description: Actual temperature reading is not increasing based on desired level.
SOLUTION:
The heating element may be broken or is at the end of its life and needs to be replaced.
PROBLEM 4: THE UNIT IS VIBRATING TOO MUCH
SOLUTION: Check if the pump is properly secured. Unplug the system from the main power
source before opening the case to check inside the station.
PROBLEM 5: THE UNIT IS VERY NOISY
SOLUTION:
Make sure the screw at the center of the base of the main unit has been removed. This holds
the pump in place during transportation and needs to be removed before using the equipment.
PROBLEM 6: UNIT SHOWS UNCONVENTIONAL BEHAVIOR
Description: Unit operates erratically.
SOLUTION: Try to switch OFF the device and switch ON again.
OTHER PROBLEMS NOT MENTIONED:
Contact the vendor.
3
The Aoyue int 852A+ pro/ int 852A++ pro SMD Rework is a
reworking tool designed to remove and/or repair surface mounted
devices such as SOIC, CHIP, QFP, BLCC, BGA, and so on.
It has several safety features such as the auto-cooling process of
the Hot Air Gun. This functionality protects the device (and its
components) from excessive heat upon reaching any of the following
conditions: (1) when the soldering gun remained idle on its resting
handle after a certain period and (2) when the temperature of the
device is above a safe threshold upon turning off.
PRODUCT DESCRIPTION
SPECIFICATION
Specifications are subject to change without prior notice.
Station Dimensions
188 (W) x 127 (L) x 244 (D) mm
Weight
3.8 Kg.
Power Input
AC 110-220 V / 50-60 Hz
Power Consumption
500 W
Temperature Range
100°C - 480°C
Heating Element Type
Metal Heating Core
Pump/Motor Type
Diaphragm Special-Purpose Lathe Pump
Air Capacity
23 l/min (Max)