aoyue INT 738, Instruction Manual

Page: 11 / 12

14
OPERATING GUIDELINES
Auto­sleep mode — unit is also programmed to have an auto­sleep
mode, this is activated when hot air gun is turned on but is placed on the
hot air gun holder and not put to use for set amount of minutes,
temperature automatically decreases and eventually turns to sleep mode.
When the handle is held up again the unit will go back to its previous
setting.
Sleep Mode Timer Set­Up
1. Switch the unit ON (or press “Reset” button, from the panel).
2. Press and hold hot air gun up button, while the Name and model is
displayed.
3. Display panel, will initially indicate ‘­0 5­ ’, which means the device will
switch to sleep mode after 5 minutes (default) of idle time and if the
nozzle is docked on the handle for the duration of time.
4. Adjust the time before sleep by pressing air pressure up and down
buttons.
5. Press Hot air gun down button to confirm.
6. The device will start counting down when the hot air gun is docked on
the handle. Once countdown is finished and the hot air gun still docked,
the device will automatically blow air (at room temperature) to bring
down temperature to 90
o
C. The panel will then display four dashes “­ ­ ­
­ “ to indicate that the device is now in sleep mode.
NOTES:
●
Time is configurable from 1 to 20 minutes (default 5 minutes).
●
The device has a switch located at the handle (cradle), which activates
the countdown before the system goes to sleep.
●
Once the hot air gun is released from the handle during sleep mode,
the unit will automatically switch back to previous working
temperature and airflow level parameters.
●
Timer settings defaults back to 5 minutes every time the unit is
powered down or the reset button is pushed.
11
OPERATING GUIDELINES
B. HOT AIR GUN
1. Switch ON the equipment by activating main power switch (9).
2. Activate HOT AIR GUN function switch (15) from the right side of the
control panel.
3. The system will immediately blow air from the hot air gun while
gradually increasing the air temperature to the default value of 99°C.
The ball inside the air gauge will also settle somewhere in the middle of
the visible area, corresponding to an air pressure level of 50. The
display area for hot air temperature and air pressure level, items 11
and 12, respectively, will show the
following.
4. Adjust air pressure using the AIR PRESSURE control buttons (3).
5. Adjust hot air temperature using the HOT AIR GUN temperature control
buttons (2). Note: When increasing or decreasing the air temperature,
the prefix of the display area for hot air gun temperature (11) will
temporarily change from uppercase “H” to lowercase “h”, indicating
that heat is being adjusted. Once the buttons are released, it will
switch back to its original case while the temperature value also
gradually increases or decreases and until the desired temperature is
reached.