
30
Retrieving a job
You can copy a job that has already been stored in one program location to any other
program location. To copy a job, proceed as described below:
1.With the “CALL” button (4), indicator is on
(22)-the last job used is displayed. To view
settings programmed in this job, use the
“Parameter selection” buttons (2) and (3).
The process and operating mode of the
stored job are also displayed.
2.With the adjustment dial (1), select the
desired job
3.With the “CALL” button (4), indicator (22) is
off. Exit from the retrieving mode.
Job correction
1.Set the welding parameters that you want to
store as a “Job”
2.Briefly press the Store button (5) to change
to the job menu. The first vacant program
location for the job is now indicated
3.Select the program location with the
adjustment dial (1), or else leave the
suggested program location unchanged.
4.Press and hold the Store button (5). The left
display reads “Pro” –the job is stored in the
program location you have just selected.
5.“PrG” appears on the left display to indicate
that the job is now stored. Release the Store
button (5). If the selected program location
already has a job stored in it, then this existing
job will be replaced by the new job.
6.Briefly press the Store button (5) to exit from
the job menu.