filter
adapter
PG.8
CLEANING & MAINTENANCE
1. To preserve the finish on the metallic parts of your ANZZI faucet, apply non-abrasive wax, such as
car wax. Any cleaners should be rinsed off immediately.
2. Clean the aerator regularly for calcium build up or any blockage that reducing water flow.
Caution
: Check all connections for leaks. Retighten if
necessary, but do not overtighten.
3.1
3.2
4. If the problem cannot be solved by measures at above
point 3, please clean the filter at the control box.
a. Turn off the handle and disconnect the outlet
hose from the control box.
b. Remove the adapter from the control box.
c. Clean the filter with brush and clean water only.
d. Install the filter and adapter back to the control
box and tighten. DO NOT OVER TIGHTEN.
e. Connect the outlet hose to the control box.Tug
the outlet hose upward to test engagement.
3. If the water flow lower than normal, please clean the filter at the inlet hoses.
a. Remove the hot and cold supply hoses (Fig 3.1).
b. Insert each hose into a cup of clean water and agitate it back and forth for 15 seconds to
remove any possible debris. Take out the hose from cup and drain (Fig 3.2).
c. Connect the supply hoses back to the supply valves. Tighten the nuts of the supply hoses
but do not over tighten.
d. Turn on hot and cold water supplies and check all connections for leaks. Retighten if necessary,
but do not overtighten.
