Anywave PA-VIII1-C-FA, User Manual, Page: 21 / 27

PA-U01-C-FA User Manual
ACT-PAVIII1-USR-DOC-V1.0, 06/25/2018 Page 21 of 27
Network Screen : The User can check and set all the Contoller network information in this screen.

Re-Defualt: Reset Default settings - This button is used to set all the network settings to the
default values, as show below:
IP: 192.168.1.210
MASK: 255.255.255.0
GateWay: 192.168.1.1

Set: There is a Set button for each bar in this screen. Pressing the Set button will lead to the
corresponding configuration screen of IP or Mask or GateWay accordingly. Using the IP setting
as example, Press any part of the white bar on the IP Setting Screen and the keyboard (shown
below) will be enabled, turing from grey to yellow. The user can only set 3-digits of one bar at a
time. When the configuration is finished, press OK to confirm. If the keyboard is enabled by
mistake, press Cancel to exit the setting mode. Don’t press Ok without entering a valid number,
otherwise the system will fill it with all zeros instead.