2. OPERATING THE BOAT
__PAGE 13
WARNING
2.5
S
TARTING THE BOAT
2.5.1 Starting the engine
Read the engine owner’s manual carefully, as the boat may be equipped with several
engine brands and models.
Ensure that there are no fuel or oil leaks in or around the engine.
Check that the main power switch and the remote switch for the starter battery are
turned on (for location and function, see chapter 5.3).
Make sure the engine gear shift is in neutral position (propeller will not rotate when
engine starts) and that the engine propeller is properly submerged in water and away
from any objects or persons.
Start the engine according to the manufacturer's owner’s manual. If the engine does not
start, or function poorly, check for instructions in the manual. If unsuccessful, contact
your engine dealer (in most cases it is your Anytec dealer).
2.5.2 After starting the engine
Ensure that the cooling system is working properly, by visually checking the cooling
water control beam (visible just below the engine hood, well above water level). If water
doesn’t flow out after start, the engine will be soon overheated which can cause serious
engine damage.
Your engine is equipped with visual and sonic alarms for critical malfunctions such as
overheating. Read the engine manual and make sure you understand these alarms. If
alarm goes off, turn off the engine immediately and check the likely reason as per the
engine manual and correct it. If the problem continues, contact nearest Engine/Anytec
dealer.
Do not turn off the main power switch while the engine is running and ensure that no
exhaust fumes get inside the boat or endanger others.
2.5.3 Leaving shore
The crew releases each mooring rope etc. as per your instructions. Make sure mooring
ropes or other ropes does not tangle with the propeller.
Ask crew to be seated as soon as possible after leaving mooring position. For seating
positions see chapter 3.6.
The emergency shutdown switch
Attach the lanyard of the emergency switch (see chapter 2.2) to your hand or lifejacket,
immediately after loosening the mooring ropes. More specific instructions of the switch
can be found in the engine manual. Especially when you are driving the boat alone it is
crucial that the boat stops if you fall overboard or stumble on board.
Anytec 747CAB Owner's Manual English V9.pdf 21
1/18/2018 7:37:25 PM
Anytec 747CAB Owner's Manual English V9.pdf 21
1/18/2018 7:38:24 PM
Summary of Contents for 2018 A27
