VERTICAL CONTACT TOASTER
14
P/N 1011287 Rev. E 02/18
TROUBLESHOOTING (continued)
Problem
Possible Cause
Corrective Action
Product is getting stuck or
conveyor belts stop when
product is toasting.
Not enough voltage, defective
power cord or rocker switch.
Contact your Maintenance Person or Antunes
Technical Service for service.
Wiring problem.
Contact your Maintenance Person or Antunes
Technical Service for service.
Conveyor drive motor inop-
erative or incorrect conveyor
motor installed on toaster.
Contact your Maintenance Person or Antunes
Technical Service for service.
Conveyor Belt chain is loose,
worn, or broken or the motor
drive sprocket is loose..
Check drive chain for kinks, broken or bent links
or other damage. Check motor sprocket and drive
sprockets (on drive shaft); tighten setscrew on flat of
shaft if required. Check for damaged/worn sprockets
and replace as required.
The Conveyor Covers are not
installed or are improperly
installed.
Install conveyor cover assy(s).
Conveyor Belts chains are
installed incorrectly.
Reinstall conveyor belt.
Conveyor Belt Chains are
too loose or are missing links
(41 links required when new).
When new, the Conveyor Belt
chain has 37 large links and
4 small links.
Remove conveyor belt. Lay belt flat and count links.
Replace entire belt if links are damaged. If conveyor
belt has too much play, it will jam. Adjust belt length
as described under Servicing the Conveyor Belt.
The Roller Tensioners or
Tensioners are bent or miss-
ing.
Replace Roller Tensioner assy(s). or tensioners if
damaged or loose. Replace slide rails if worn or miss-
ing.
