- 5 -
light normally. Please always replace a full fluid bladder. Otherwise, it might damage the pump of
generator.
LED & Buzzer Status Table
Machine Status
Buzzer
LED
Machine Overheating
1 short beep every 5 sec.
Red flash twice every 2 sec.
Front Cover or Fluid Bag
Chamber Cover is Opened
1 long beep every 1 min.
Red flash once every 2 sec.
UPS Power Cut
3 short beeps every 30 sec.
Red flash twice every 5 sec.
AC Power Cut
2 short beeps every 30 sec.
Red flash once every 5 sec.
Heater Fault
1 long beep every 10 sec.
Red flash
Fluid Level Empty
1 long and 1 short beep every 5 min.
Orange flash
Fluid Level Low
1 short beep every 5 min.
Permanent orange
Heating Process incomplete
Long beep for 30 sec. and then 3 short
beeps every 5 min.
Permanent red
DIP 2 switch to ON
No buzzer
Red and green flash together
Normal
No buzzer
Permanent green
Armed
No buzzer
Green light flashes slowly
Test the security smoke generator
Once Antari security smoke generators reach ready status (Green LED On), you can carry out a simple
test at generators to check the smoke production.
Open the front cover, and press and hold down the “PB1“test button. The machine will produce smoke.
Smoke production ceases once the “PB1”test button is released.
Thank you very much again for your patience and reading this manual. If you have any further question
about our products, please do not hesitate to contact your local distributor or Antari directly.
Antari contact information
Email:
Tel: +886-3-322-5829 Fax:+886-3-322-7035
No. 8, Lane 231, Nankan Rd., Sec.1, Lujhu, Taoyuan county, Taiwan
