Antari DNG-200, User Manual

Page: 9 / 32

D
N
G
-200
User Manual
07
The -200 is equipped with a 512 system. For connecting a controller, 3-pin DNG DMX DMX
and 5-pin male-female connections are provided at the back of the machine. The XLR
machine uses one control channel for adjusting the output volume. The channel has a
DMX
DMX value range of 0 to 255. After connecting a controller, timer functions such as
output duration and interval can be programmed using the controller or the DMX DMX
control software. The machine cannot be controlled via the D-20 control anymore. By
using the
protocol, fog machines, lighting effects, and other special effects machines DMX
can be interconnected and easily controlled.
Between the values 0 to 31 the machine does not have sufficient output volume and is off.
Between the values 31 to 126 the machine has a minimal output volume of 35%.
Between the values 127 to 191 the machine has a medium output volume of 52 %.
Between the values 191 to 255 the machine has a maximum output volume of 60 %.
192 - 255 = high volume (60 % output)
127 - 191 = medium volume (52 % output)
32 - 126 = low volume (35 % output)
0 - 31 = off (no fog output)
English
After operation, please wait 15 minutes before turning off the machine.
Please do not turn the power on and off continuously. There must be at least a one-
minute interval between each power on and off.
Operate the machine in a well-ventilated area.
Do not position two or more
-200 machines side by side to prevent poor hot air DNG
ventilation.
Do not operate the machine under direct sunlight.
It is strongly suggested not to have the machine produce continuous fog output over 20
minutes. Overtime usage might reduce the efficiency and lifespan of the compressor.
Please save this user manual carefully.
-DMX512 Settings
-Operation Notice