D
N
G
-200
User Manual
03
Connect the machine with the black fog conducting hose it is a three-meter pipe. The
;
length of the pipe can be adjusted to fit the actual need. (refer to figure 4)
Fill Antari FLC super fast dissipating liquid or FLR light fog liquid to the tank, tighten the
tank cap. (refer to figure 5)
Figure 4
Figure 5
Connect the power cord to a grounded outlet, press down two sets of power switches
located at the back side of the machine. Please press the power switch of the
compressor below first and then the power switch of the fog machine. The warm up
-
process is started. The
screen on the D-20 controller will show "Warming up”.
LCD
While the unit is warming up, fog output will not be possible yet. Please wait till the LCD
screen shows "Ready To Fog".
Program the necessary menu settings with the control panel of the D-20 controller.
(refer to chapter D-20 controller).
The
-200 is equipped with a
512 system. 3-pin and 5-pin
connectors
DNG
DMX
DMX
each are located at the back panel of the machine for optional use. (refer to chapter
DMX512 settings)
When operating the machine for the first time, wait until the controller's
screen
LCD
shows "Ready To Fog”. Actuate the button
for a few seconds to initiate fog
Manual
output from the machine. Thus the air in the liquid pipe is drained out. Once the fog
comes out smoothly, the D-20 controller can be set. If the machine is used infrequently,
please follow this procedure every time it is used to drain out the air.
The heater average temperature of the
-200 is 220°C.
DNG
-Operation
The D-20 controller is equipped with a 2-meter line, a 5-pin
connector, and an
XLR
LCD
screen displaying all operation statuses of the fog machine. The interface allows the
operator to customize fog machine functions by adjusting the fogging duration, interval,
and
as well as the
address
volume
. There are six buttons on the control board. All
DMX
current operating parameters are automatically stored in non-volatile memory, allowing
the machine to be powered down without losing function settings.
-Configuration of the buttons
-D-20
Screen Controller
LCD
FUNCTION
VOLUME
TIMER
MANUAL
English
1.
Interval Set
Duration Set
Volume Out
Nonstop Burst
High Volume
Medium Volume
Low Volume
512 Add
DMX
2.
and
UP
DOWN
3.
TIMER
4.
VOLUME
5.
MANUAL
TIMER
VOLUME
MANUAL
Summary of Contents for DNG-200
Page 2: ...English 01 07 08 15 16 22 Fran ais 23 29 German...
Page 31: ......
