Antaira Industrial Ethernet Switches
LMP-0501 Series User Manual V1.0
24
Channel
ERPS Channel ID, ranges from 1 to 4094. It’s a channel to send PDUs of
ERPS.
Revertive
Set to Revertive (yes) or Non-revertive (no). The revertive mode works only
under scenario A at the RPL Owner node.
[Revertive]
While the revertive mode is set, the RPL link will be blocked in 5
minutes after recovery form link failure situation. Otherwise, it will remain
unchanged of the blocking state. That is, the failed link port will block
permanently until the next event happen.
[Non-Revertive]
The failed ring link the port attached to it will remain blocked
even the situation is eliminated.
Click the
“Apply” button to save changes.
5.5.3 Before Configuring ERPS
Before configuring ERPS, the rapid spanning tree protocol (RSTP), or multiple spanning tree
protocol is required to be disabled, because only one protocol can be exclusively running within
a switch. Below are the steps to disable RSTP or MSTP.
Step 1:
Login to the switch with a web browser.
Step 2:
Open the “RSTP Configuration” page under the “Spanning Tree” manual as
shown below in
Figure 5.21
.
Figure 5.20
– ERPS Configuration Terms & Description
Figure 5.21
– Spanning Tree Manual
