4.1 Point-to-Point Application – LAN
to LAN Connection
Two sets of the EVC-3101 could be used to link two local Area networks that are located in a different
place. Through the normal telephone line, it could be set up a 150/150Mbps (G.INP, Sym, 8dB)
symmetric backbone, but one EVC-3101 must be Master (CO mode) and the other one is Slave (CPE
mode).
Refer to the following procedures to set up the EVC-3101 LAN to LAN connection.
1.
[LAN1] Set the EVC-3101 at LAN 1 to be CO mode from the DIP switch
2.
[LAN2] Set the EVC-3101 at LAN 2 to be CPE mode from the DIP switch
3.
Power on the EVC-3101 CO and CPE at both sides by connecting its power source.
4.
Power LED will illuminate.
5.
Connect VDSL line from another VDSL device to RJ11 VDSL port of the EVC-3101.
6.
VDSL LNK LED will blink to illuminate at both EVC-3101 devices.
7.
Connect telephone to the RJ11 Phone port of the EVC-3101.
8.
Connect the EVC-3101 Ethernet LAN port to other network device via regular Cat.5 UTP cable.
